友情链接: 澳门银河老虎机 澳门巴黎人手机网址 永利老虎机 澳门葡京官方赌场 葡京手机平台 葡京官方下载 澳门永利导航 永利百家乐 澳门金沙导航 澳门银河客户端 澳门葡京导航 永利手机平台 澳门永利官方下载 葡京客户端 葡京官方网址 澳门葡京官方注册 澳门永利老虎机 银河老虎机 永利手机网站 永利客户端 银河手机网址 金沙百家乐 澳门葡京现金网 金沙客户端 澳门葡京手机网站 金沙官方注册 澳门巴黎人导航 澳门银河轮盘 巴黎人官方赌场 永利官方注册 澳门葡京百家乐 澳门葡京官方下载 澳门金沙官方下载 葡京手机网站 澳门葡京手机平台 巴黎人老虎机 澳门金沙百家乐 澳门永利手机平台 澳门金沙客户端 澳门永利官方网址 银河官方网站 澳门葡京老虎机 巴黎人官方网站 葡京手机网址 葡京官方网站 葡京老虎机 澳门金沙官方注册 银河官方注册 澳门巴黎人百家乐 永利官方网址 金沙现金网 澳门永利官方网站 澳门葡京官方网站 澳门金沙轮盘 澳门永利官方注册 葡京轮盘 澳门巴黎人手机平台 澳门葡京官方网址 澳门永利百家乐 巴黎人轮盘 银河官方网址 澳门巴黎人客户端 巴黎人手机平台 澳门银河官方赌场 澳门巴黎人官方赌场 澳门银河官方下载 澳门金沙官方网址 金沙手机平台 银河现金网 巴黎人手机网站 永利官方下载 银河官方赌场 澳门永利手机网站 澳门巴黎人官方网站 澳门银河官方网站 澳门银河官方网址 澳门巴黎人官方注册 澳门威尼斯人官网 永利现金网 澳门金沙手机网站 银河客户端 澳门银河手机网址 澳门葡京客户端 巴黎人现金网 澳门巴黎人现金网 银河手机网站 澳门巴黎人老虎机 金沙手机网址 澳门巴黎人官方下载 澳门葡京轮盘 澳门金沙老虎机

Welcome to Guangzhou Wanchang Sound Co.,Ltd.

Common fault and maintenance method of sound box

2016-07-14 15:00:00

Multimedia speakers as computer sound equipment, is a relatively low technological content of products, but its failure rate is relatively high and fault mostly concentrated in power amplifier block and a power supply part, below the author combined with own experience about multimedia speaker of the common faults and maintenance repair methods, hoping to be helpful to everyone.

Insulation fastener

Part of the power failure in general transformer and rectifier circuit, transformer short circuit, fuse circuit, rectifier tube breakdown; failure phenomenon or the silent sound of exchange, endanger among them the biggest is short circuited transformer, which will enable transformer temperature rise sharply until burned, and even lead to a tank fire. If the rectifier tube breakdown short circuit will lead to more than two short circuit, therefore, in the case of sudden silence when the speaker should immediately turn off the speaker power, to find out the failure to try again. Transformer only need to change can be the same model, the rectifier can generally be direct substitution, fuse is easier and more for a can.

If the fault in the power amplifier section, the phenomenon is more: there is the exchange of sound, silence, only one vocal tract, noise, etc.. Because now most speakers integrated amplifier function, so the circuit is simple, and the power amplifier block are generally metal backboard is fixed at the back of the speaker, it is useful in the heat, is also very good looking. If the power amplifier block has a fault, the boot after the temperature will increase, so the metal backboard will be very hot, even hot. Encountered such problems for a power amplifier block can generally be resolved.

If the speaker's power is larger, the audio output section will be placed in a protective circuit to prevent excessive damage to the speaker. In fact, this circuit is a few ohm or a few ohm resistor, when the volume is too large, the temperature of the resistance will increase, to a certain extent will be burned off, to protect the role of the speaker. Because the resistance is very small, so if there is no suitable, instead of a piece of wire can be used, but it is recommended with the same type of resistance, unless you have no use for large volume. Otherwise, you just wait for the horn.

Speaker failure is relatively rare, because most of the power of multimedia speakers are not very large, but do not rule out the possibility of. If the speaker sounds more noisy, and accompanied by noise, while the circuit part of the trouble, you can determine the speaker is the problem, then only change the speaker.

These fault is judged by observing, and other types of fault analysis requires some circuit analysis techniques the, so if you are not familiar with the electronic technology, through the above "look, smell, ask," the law, first diagnosis of speakers which part of a problem, and then find someone to repair.